|
Serial Interface |
All data and commands are
handled through serial interface (8,N,1).
Communication rates from 300 to 115,200 baud.
|
|
Analog
I/O |
Input impedance of measured
circuit: <10K ohms
11 channels (10 brought out to terminal strip pads) 0-5 VDC regulable, single ended.
Sample rates to 1250 sps transferred to the computer (8 bit) at 115,2000 baud. |
|
Digital
I/O |
8 I/O TTL compatible pins
organized in 1 port (PA) can be configured as INPUT or OUTPUT on a pin by pin basis.
Direct read back of all digital outputs.
|
|
Pulse Width
Modulation |
10-10,000
pps, 0-100% duty
cycle in 1% steps.
|
|
Stepper Motor
Control |
Step rates from 10 to 3,300
steps/sec
Monophasic/Biphasic and Half step operation. |
|
Power
Supply
|
The ST board contains a
7805 regulator capable of supplying up to 1 Amp at 5VDC that can be used to power external
circuitry. A 6.5 – 9V, 500 mA adapter is recommended. |
|
PC
communication
|
A DB9 connector on the ST
board can be linked to the serial port of a computer or terminal. |
|
Dynamic
Library |
Dynamic Link Library in 16
and 32 bit versions. |
